12V Single Channel Relay Module 10A
Review: 5 - "A masterpiece of literature" by , written on May 4, 2006
I really enjoyed this book. It captures the essential challenge people face as they try make sense of their lives and grow to adulthood.
Quality Filament without breaking the bank

Shop Kobee PLA+
Main Categories
Featured Products
Inkjet / Laser Printable Sticker Vinyl Paper Multi Packs - White - 10 Sheets - - Kobee
Inkjet / Laser Printable Sticker Vinyl Paper Multi Packs
$9.99
Solder Sleeve Wire Splice Terminators - 100 Pack - - - - Kobee
Solder Sleeve Wire Splice Terminators - 100 Pack
$9.99
Arduino Uno R3 - - - - Kobee
Arduino Uno R3
Sold Out
Arduino Uno R3 Starter Pack
Arduino Uno R3 Starter Pack
Sold Out
24 LED RGB Neopixel Rings - WS2812B - - - - Kobee
24 LED RGB Neopixel Rings - WS2812B
$8.99
Arduino Uno R3 Essentials Pack
Arduino Uno R3 Essentials Pack
Sold Out
  • Free Delivery
    Over $120
  • Low Prices
  • Awesome Support
  • 100%
    Australian Owned
Kobee

12V Single Channel Relay Module 10A

Add Your Review
Available: Out of Stock
$3.99
Pre-order
Successful pre-order.Thanks for contacting us!

These versatile 12V relay modules allow you to control larger devices up to 10A using whatever flavour of microcontroller you prefer or even a simple button

  • Compatible with all microcontroller boards including Arduino and ESP variants
  • The relay is designed to operate up to 30VAC or 30VDC at 10A
  • Capable of controlling 1 device (Single Channel)
  • 2 onboard LEDs show you the state of the relay
  • The relay is activated when the input pin is pulled low to ground. If the input pin is floating or at VCC, the relay will inactivate

Refer to Pinout tab for an explanation of the relavent pins on the module


Note
  • Ensure that both the input signal IN and voltage VCC are the same. Ie. 12V
Warning
This board is not designed to be utilised with mains voltages and is intended for low voltage applications only.


Working with high voltage electricity can result in personal injury and / or property damage

These versatile 12V relay modules allow you to control larger devices up to 10A using whatever flavour of microcontroller you prefer or even a simple button

  • Compatible with all microcontroller boards including Arduino and ESP variants
  • The relay is designed to operate up to 30VAC or 30VDC at 10A
  • Capable of controlling 1 device (Single Channel)
  • 2 onboard LEDs show you the state of the relay
  • The relay is activated when the input pin is pulled low to ground. If the input pin is floating or at VCC, the relay will inactivate

Refer to Pinout tab for an explanation of the relavent pins on the module


Note
  • Ensure that both the input signal IN and voltage VCC are the same. Ie. 12V
 Warning This board is not designed to be utilised with mains voltages and is intended for low voltage applications only.


Working with high voltage electricity can result in personal injury and / or property damage
Single Channel Relay Pinout


Label Name Notes
NO Normally Open Pin is normally disconnected fromcommon unless relay is activated
COM Common Connected to circuit you are planning to switch
NC Normally Closed Pin is normally connected to common unless relay is activated
VCC Voltage input Input Voltage for control circuit and relay coil - 12
GND Ground Common Ground Connection
IN Input Pin used to control the relay (Connected to output of microcontroller or switch. Pin is active low meaning it will be activated when you pull the pin low