0.25-0.34mm Solder Sleeve Wire Splice Terminators
![Arduino Uno R3 - - - - Kobee]()
![Arduino Uno R3 Starter Pack]()
Features
Main Categories
Featured Products
0.25-0.34mm Solder Sleeve Wire Splice Terminators
Available:
In Stock
- Product SKU: ZZ001
- Category: Best Sellers, Cables and Cable Management, Connectors, Featured Industrial, Heat Shrink, New Products, Solder Sleeves
$3.49
Kobees low melt solder sleeve connectors are perfect for connecting two wires together without the need for crimp tools or traditional cumbersome twist and solder techniques.
With the use of a hot glue gun or lighter you can quickly create a fast, waterproof and electrically reliable fully insulated connection
Features
- Fully Insulated Connection
- Doesn't require crimping tools or solder
- Fast, Waterproof and electrically reliable connection
- 2:1 Ratio Heat Shrink
Specifications
- Length: 26mm
- Diameter: 1.7mm
- Suitable Wire Sizes: 0.25-0.34mm2 (26-24 AWG)
Instructions
- Strip both ends of the wires you want to connect
- Add a properly sized connector down one side (much like you would add some heat-shrink tubing)
- Twist the exposed wires together.
- Slide the connector so that the ring of solder is in place around the bare wires.
- Heat up with a heat gun (preferred) or lighter and watch the tubing shrink and the solder flow into the connection. Make note that the tubing will begin to shrink first, and after a little time the the solder will soften and begin to flow around the wires.
- Hold the connection until the solder and connector has cooled
