Wemos D1 Mini SHT30 Temperature & Humidity Shield
![Arduino Uno R3 - - - - Kobee]()
![Arduino Uno R3 Starter Pack]()
Note 1:
See the front of the module for the I2C address. Each module has two available addresses which use a solder bridge to select. By default, use the address without the bridge installed, this will work for most applications
If you need a different address then the default one, solder the 2 address bridge pins together and refer to the alternatice address/section>
Main Categories
Featured Products
Wemos D1 Mini SHT30 Temperature & Humidity Shield
Available:
In Stock
- Product SKU: AB150
- Category: Best Sellers, Humidity Sensors, New Products, Sensors, Temperature Sensors, Wemos
$9.99
The Wemos D1 Mini SHT30 temperature sensor shield is a digital temperature and humidity sensor that is able to test to an accuracy of +/-0.3 degrees and +/-3% relative humidity
The board is compatible with D1 mini, D1 Mini pro and D1 mini lite. Although the board is intended to be a direct shield add on for the D1 mini range of products, you can connect to it from any microcontroller via I2C
The board uses the SHT30 sensor which is able to be easily communicated with via open souce drivers through the Arduino IDE
Refer to Pinout tab for an explanation of the relavent pins on the module
| Label | Name | Notes |
|---|---|---|
| D1 | SCL | SCL Communication Pin |
| D2 | SDA | SDA Communication Pin |
If you need a different address then the default one, solder the 2 address bridge pins together and refer to the alternatice address/section>